Hey gang,

I'm going to do my first run of 8x20 today. It's HP5+ and I'm going to run it on the JOBO using the 3063 drum.

I'm wondering if I dare put two 8x20's in this drum which is designed to take 1 16x20. I test-fit a sheet of film in there, and it seems like there's plenty of room...one thing I'm concerned about though, is the film popping out of the groove and ending up sitting flat in the center of the drum.

Any advice/suggestions for processing in this tank? Should I do them one sheet at a time?

I'm going to go with a standard developer and take away 15% of the time to compensate for the rotation development.

Any advice about that?