Hey all, been reading around here a lot but not too much posting. I just got a bunch of new (read: old) darkroom gear and had a question about the print dryer. It is a durst RCD 2500 made in West Germany to give you an idea how old it is. It seems to work great put a couple of prints through it and dried perfectly. The problem is the foam on the two bars in the rear is disintegrating to the point of filling the prints with brown dust. is there a way to refoam these bars or get replacement bars. done a lot of searching here and on google and found nothing. I am pretty good with electricity and my roommate is good with mechanics so it might be something i can fix, if anyone has any input it would be greatly appreciated.