[dancqu]

When I remove prints from the dry mount press I often have
wrinkles at the short edges. At times they have been wrinkled
enough to become pleats. Happens on 1620 and 2024 paper
most often, but does happen on 1114 from time to time.
Anyone know of the cause?

I was having the same problem, wavy edges, using my
corrugated board stack dryer. The prints were drying faster
at the edges. By increasing the print's overlap of separator
sheets and corrugated board the problem was eliminated.
All four edges very straight and smooth. Still that gentile
bend towards the emulsion side after setting out but I'm
working on that.

Are you mounting or just drying? Dan